What is epoxy flooring? Epoxy flooring is a seamless resin surface made by applying a two-part epoxy, a resin and a hardener that cure into a hard, durable plastic, usually over a prepared concrete slab. The result is a tough, chemical-resistant, easy-clean floor with no joints for dirt to gather in, which is why epoxy […]
Monthly Archives: July 2026
03
Jul
Jul
Why do resin floors fail? Resin floors almost always fail because of the substrate and the preparation beneath them, an unsuitable specification or mistakes made during mixing and application, not because the resin itself has worn out. Peeling, blistering, cracking and rapid wear nearly always trace back to a slab that was contaminated, damp, weak […]
03
Jul
Jul
Concrete moisture testing for resin flooring Concrete moisture testing measures how much moisture is in or moving through a slab before a resin floor is laid, because water vapour rising through concrete can lift and blister an impervious resin surface. Testing the slab, rather than assuming it is dry, is how moisture-related failures are prevented […]
03
Jul
Jul
Crack and joint repair before resin flooring Cracks and joints in a concrete slab are repaired before a resin floor is laid because untreated cracks and movement joints telegraph straight through the new surface and become points of failure. Static cracks are cut out and filled with resin mortars so they do not reflect through […]
03
Jul
Jul
Damp-proof membranes for resin floors A damp-proof membrane for a resin floor is a moisture-suppressing layer applied to a concrete slab that reads too high for moisture, holding the vapour back so the resin floor above it stays bonded rather than blistering. It is the practical answer when a slab cannot be laid on directly, […]
03
Jul
Jul
Diamond grinding vs shot blasting: which prepares a floor for resin? Neither diamond grinding nor shot blasting is simply better; they are two ways of mechanically profiling a concrete slab for resin and each suits different floors. Diamond grinding uses rotating diamond discs to abrade the surface flat and open and suits smoother finishes, detailed […]
03
Jul
Jul
How to tell if your concrete is ready for resin flooring Concrete is ready for resin flooring when it is sound, clean, dry and properly profiled, meaning the slab is structurally solid with no crumbling or delaminating areas, free of oil, dust and old coatings, tested and within moisture limits and mechanically ground or blasted […]
03
Jul
Jul
Resin flooring for commercial kitchens Resin flooring is well suited to commercial kitchens because a polyurethane resin screed gives a seamless, hygienic, slip-resistant surface that copes with grease, hot spillages, wash-downs and constant cleaning and supports food-safety compliance as one part of the kitchen’s wider hygiene regime. Kitchens combine wet, heat, fats and heavy cleaning […]
03
Jul
Jul
Best flooring for breweries and distilleries The best flooring for breweries and distilleries is a polyurethane resin screed in the wet production areas, because it handles the constant wet, the hot wash-downs and steam, the sugary and mildly acidic spillages and the need for slip resistance far better than a standard epoxy. These environments are […]
03
Jul
Jul
Best flooring for distribution centres The best flooring for a distribution centre is a hard-wearing resin system matched to the traffic and layout, typically a high-build epoxy over a sound, flat concrete slab with abrasion resistance, dust control, clear line marking and well-treated joints. In a new build the power-floated slab does much of the […]